Nissan Versa

 Sedan Service Manual

Transmission & driveline » Transaxle & transmission (TM) » Precautions
Removal and installation procedure for CVT Unit connector

REMOVAL

• Rotate bayonet ring (A) counterclockwise. Pull out CVT unit harness connector (B) upward and remove it.

INSTALLATION

1. Align marking (A) on CVT unit harness connector terminal with marking (B) on bayonet ring. Insert CVT unit harness connector.
2. Rotate bayonet ring clockwise.

    3.   Rotate bayonet ring clockwise until marking (A) on CVT unit harness connector terminal body is aligned with the slit (B) on bayonet ring as shown in the figure (correctly fitting condition).

CAUTION:

• Securely align marking (A) on CVT unit harness connector terminal body with bayonet ring slit (B). Then, be careful not to make a half fit condition as shown in the figure.
• Do not mistake the slit of bayonet ring for other dent portion.

PREPARATION

Special Service Tools

*: The O-ring as an unit part is set as a SST.

Commercial Service Tools

Precaution for supplemental restraint system (SRS) "Air bag" and "Seat belt pre-tensioner"

General precautions

On board diagnosis (OBD) System of CVT and Engine

Removal and installation procedure for CVT Unit connector