Nissan Versa

 sedan Owners Manual

Do-it-yourself » Lights
Exterior and interior lights

Always check with the Parts Department at a NISSAN dealer for the latest parts information.

* It is recommended that you visit a NISSAN dealer for replacement.

1. Map lights (if so equipped)

2. Room light

3. Door mirror turn signal light (if so equipped)

4. Headlight assembly

5. Fog light (if so equipped)

6. High-mounted stop light (spoiler) (if so equipped)

7. License plate light

8. Trunk light

9. High-mounted stop light (inside) (if so equipped)

10. Rear combination light

Replacement procedures

All other lights are either type A, B, C or D. When replacing a bulb, first remove the lens, lamp and/or cover.

Indicates bulb removal

Indicates bulb installation

Map lights (if so equipped)

Use a cloth to protect the housing.

Trunk light

License plate light

Rear combination light

To change the stop/tail, turn signal or backup (reversing) light bulbs, perform the following: 1. Disconnect the negative battery cable.

2. Remove the two clips A and carefully pull the carpet back.

3. Remove the two nuts B and the rear combination light from the vehicle.

4. Disconnect the electrical connector C from the rear combination light.

5. Remove four screws D and the housing from the rear combination light.

6. Replace the necessary bulbs.

Follow the instruction in reverse order to install the rear combination light and carpet.

Headlights

Fog lights (if so equipped)

Exterior and interior lights