Nissan Versa

 Sedan Service Manual

Engine » Engine control system (EC) » Engine control system
EVAP Canister Vent Control Valve

The EVAP canister vent control valve is located on the EVAP canister and is used to seal the canister vent.

This solenoid valve responds to signals from the ECM. When the ECM sends an ON signal, the coil in the solenoid valve is energized.

A plunger will then move to seal the canister vent. The ability to seal the vent is necessary for the on board diagnosis of other evaporative emission control system components.

This solenoid valve is used only for diagnosis, and usually remains opened.

When the vent is closed, under normal purge conditions, the evaporative emission control system is depressurized and allows "EVAP Control System" diagnosis.

EVAP Control System Pressure Sensor

The EVAP control system pressure sensor detects pressure in the purge line. The sensor output voltage to the ECM increases as pressure increases.

Accelerator Pedal Position Sensor

Air Fuel Ratio Sensor 1

Air Fuel Ratio Sensor 1 Heater

Battery Current Sensor

Camshaft Position Sensor

Crankshaft Position Sensor

Engine Oil Temperature Sensor

EVAP Canister Vent Control Valve

Exhaust Valve Timing Control Solenoid Valve

Fuel Injector

Fuel Pump

Heated Oxygen Sensor 2

Intake Air Temperature Sensor

Intake Valve Timing Control Solenoid Valve

Malfunction Indicator Lamp (MIL)

Mass Air Flow Sensor

Oil Pressure Warning Lamp

Throttle Position Sensor