Nissan Versa

 Sedan Service Manual

Engine » Starting system (STR) » Diagnosis and repair workflow
Work Flow (Without GR8-1200 NI)

OVERALL SEQUENCE

DETAILED FLOW

NOTE: If any malfunction is found, immediately disconnect the battery cable from the negative terminal.

1.CHECK ENGINE START

Crank the engine and check that the engine starts.

Does the engine start?

YES >> GO TO 2.

NO >> GO TO 3.

2.CHECK THAT THE STARTER MOTOR STOPS

Check that the starter motor stops after starting the engine.

Does the starter motor stop?

YES >> Inspection End.

NO >> Replace starter motor. Refer to STR, "Removal and Installation".

3.CHECK THAT THE ENGINE TURNS WHEN CRANKING

Check that the engine turns when cranking.

Does engine turn when cranking?

YES >> GO TO 4.

NO >> GO TO 5.

4.CHECK THE ENGINE SPEED WHEN CRANKING

Check that the engine speed is not low when cranking.

Does engine turn normally?

YES >> Check ignition/fuel system.

NO >> Check charge condition, corrosion and connection condition of the battery.

5.CHECK STARTER MOTOR ACTIVATION

Check that the starter motor runs at cranking.

Does starter motor turn?

YES >> Replace starter motor. Refer to STR, "Removal and Installation".

NO >> GO TO 6.

6.CHECK POWER SUPPLY CIRCUIT

Check the following conditions:

• Fuse and fusible link
• Charge condition, corrosion and connection of the battery.

Are these inspection results normal?

YES >> GO TO 7.

NO >> Repair as needed.

7.CHECK STARTING SYSTEM WIRING

Check the following:

• "B" terminal circuit. Refer to STR, "Diagnosis Procedure".
• "S" terminal circuit. Refer to STR, "Diagnosis Procedure".

Are the inspection results normal?

YES >> Replace starter motor. Refer to STR, "Removal and Installation".

NO >> Repair as needed.

Work Flow (With GR8-1200 NI)

Work Flow (Without GR8-1200 NI)