ROOM LAMP
WARNING: Do not touch bulb with your hand while it is on or right after being turned off. Burning may result.
CAUTION: Do not touch the glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to the bulb.
REMOVAL
1. Remove lens (1) and remove the room lamp by pulling down to release the room lamp metal clips (A).
2. Disconnect the harness connector from the room lamp and remove.

INSTALLATION Installation is in the reverse order of removal.
ROOM LAMP
WARNING: Do not touch bulb with your hand while it is on or right after being turned off. Burning may result.
CAUTION:
Removal
1. Remove lens (1) by inserting suitable tool and releasing LH (switch side first).
2. Remove bulb (2).

Installation
Installation is in the reverse order of removal.
NOTE: Insert the lens hook end RH side first to install lens.
Map lampExploded View 1. Map lamp bulb housing 2. Bulb 3. Lens Pawl ...
Security systems (if so equipped)
Your vehicle has one type of security systems:
NISSAN Vehicle Immobilizer System
NISSAN vehicle immobilizer system
The NISSAN Vehicle Immobilizer System will not
allow the engine to start without the use of a
registered key.
If the engine fails to start using a registered key
(for ex ...
U0140 Lost communication (BCM)
DTC Logic
DTC DETECTION LOGIC
DTC
Trouble diagnosis name
DTC detection condition
Possible causes
U0140
Lost Communication With Body
Control Module
When the ignition switch is ON,
TCM is unable to receive the
CAN communications signal
from BCM continuously ...