M/T OIL : Inspection
OIL LEAKAGE
Make sure that gear oil is not leaking from transaxle or around it.
OIL LEVEL
1. Remove filler plug (1) and gasket from transaxle case.
2. Check the oil level from filler plug hole as shown.
CAUTION: Do not start engine while checking oil level.
3. Install a new gasket on filler plug and then install filler plug to transaxle case.
CAUTION: Do not reuse gasket.
4. Tighten filler plug to the specified torque. Refer to TM "Exploded View".

M/T OIL : Draining
1. Start engine and let it run to warm up transaxle.
2. Stop engine. Remove drain plug (1) and gasket, using suitable tool and then drain gear oil.
3. Install a new gasket on drain plug (1) and install drain plug to clutch housing, using suitable tool.
CAUTION: Do not reuse gasket.
4. Tighten drain plug (1) to the specified torque. Refer to TM "Exploded View".

M/T OIL : Refilling
1. Remove filler plug (1) and gasket from transaxle case.
2. Fill with new gear oil until oil level reaches the specified limit at filler plug hole as shown.
CAUTION: Do not start engine while checking oil level.
Oil capacity and viscosity : Refer to MA "Fluids and Lubricants".
3. Install a new gasket on filler plug and then install filler plug to transaxle case.
CAUTION: Do not reuse gasket.
4. Tighten filler plug to the specified torque. Refer to TM "Exploded View".

Clutch fluidCLUTCH FLUID : Inspection FLUID LEAKAGE Check clutch line for cracks, deterioration or other damage. Replace any damaged parts. Check for fluid leakage by fully depressing clutch pedal while ...

ROAD WHEEL : Adjustment BALANCING WHEELS (ADHESIVE WEIGHT TYPE) Preparation Before Adjustment Remove inner and outer balance weights from the road wheel. Using releasing agent, remove double-face ...
When traveling or registering in another country
When planning to drive your NISSAN vehicle
in another country, you should first find
out if the fuel available is suitable for your vehicle's
engine.
Using fuel with an octane rating that is too low
may cause engine damage. All gasoline vehicles
must be operated with unleaded gasoline. There ...
Diagnosis and repair work flow
Work Flow
OVERALL SEQUENCE
DETAILED FLOW
1.COLLECT INFORMATION FROM THE CUSTOMER
Get detailed information from the customer about the symptom (the condition
and the environment when the
incident/malfunction occurred) using the diagnostic worksheet. Refer to BRC
"Diagnostic Work Sh ...