Nissan Versa

 Sedan Service Manual

Ventilation, heater & air conditioner » Heater & air conditioning control system (HAC)
Intake door cable

INTAKE DOOR CABLE : Removal and Installation

REMOVAL

1. Remove instrument panel assembly. Refer to IP "Removal and Installation".
2. Disconnect intake door cable from A/C control.
3. Disconnect intake door cable from A/C unit assembly and remove.

INSTALLATION

Installation is in the reverse order of removal.

INTAKE DOOR CABLE : Adjustment

1. Remove instrument panel assembly. Refer to IP "Removal and Installation".
2. Disconnect intake door cable (1) from clamp (A).
3. Set intake door lever to REC position.
4. Push intake door link (2) in the direction as shown, and then carefully pulling outer cable to A/C control side, and connect clamp.
5. Operate intake door lever to insure that inner cable moves smoothly.

CAUTION: When clamping the outer cable, do not move the inner cable.

Precautions

Manual air conditioning system

Diagnosis and repair workflow

Operation inspection

A/C On signal

Blower fan on signal

A/C Indicator

Front blower motor

Magnet clutch

Insufficient cooling

Insufficient heating

Compressor does not operate

Front air control

Refrigerant pressure sensor

Blower fan resistor

Intake door cable

Mode door cable

Air mix door cable