Nissan Versa (N17): Fuses

Fuses

If any electrical equipment does not operate, check for an open fuse.

Fuses are used in the passenger compartment.

Spare fuses are provided and can be found in the passenger compartment fuse box.

When installing a fuse make sure the fuse is installed in the fuse box securely.

Engine compartment

Engine compartment

WARNING

Never use a fuse of a higher or lower amperage rating than specified on the fuse box cover. This could damage the electrical system or electronic control units or cause a fire.

Fusible links

If any electrical equipment does not operate and the fuses are in good condition, check the fusible links A in the holder. If any of the fusible links are melted, replace only with Genuine NISSAN parts.

For checking and replacing the fusible links, it is recommended that you visit a NISSAN dealer.

Passenger compartment

Passenger compartment

WARNING

Never use a fuse of a higher or lower amperage rating than specified on the fuse box cover. This could damage the electrical system or cause a fire.

If any electrical equipment does not operate, check for an open fuse.

NOTE:

The fuse box is located on the driver's side of the instrument panel.

1. Be sure the ignition switch and the headlight switch are OFF.

2. Remove the fuse box cover A with a suitable tool. Use a cloth to avoid damaging the trim.

3. Locate the fuse that needs to be replaced.

4. Remove the fuse with the fuse puller B .

Passenger compartment

5. If the fuse is open C , replace it with an equivalent good fuse D .

6. Push the fuse box cover to install.

If a new fuse also opens, have the electrical system checked and repaired. It is recommended that you visit a NISSAN dealer for this service.

Extended storage switch

Extended storage switch

If any electrical equipment does not operate, remove the extended storage switch and check for an open fuse.

NOTE:

The extended storage switch is used for long term vehicle storage. Even if the extended storage switch is broken it is not necessary to replace it. Replace only the open fuse in the switch with a new fuse.

How to replace the extended storage switch: 1. To remove the extended storage switch, be sure the ignition switch is in the OFF or LOCK position.

2. Be sure the headlight switch is in the OFF position.

3. Remove the fuse box cover.

4. Pinch the locking tabs A and B found on each side of the storage switch.

5. Pull the storage switch straight out from the fuse box C .

Brakes

If the brakes do not operate properly, have the brakes checked. It is recommended that you visit a NISSAN dealer for this service. Self-adjusting brakes Your vehicle is equipped with self-adjustin ...

Battery replacement

CAUTION Be careful not to allow children to swallow the battery or removed parts. ...

Other materials:

Calibration of G Sensor
Description TCM stores calibration data (inherent characteristic value) of G sensor to provide accurate control. Therefore, it is required to perform calibration of G sensor after the following work is performed. Removal/installation or replacement of G sensor Replacement of TCM Work ...

Transmitter wake up operation
Description This procedure must be performed after replacement of a transmitter or the BCM, or rotation of the wheels. Work Procedure NOTE: This procedure must be done after replacement of a TPMS transmitter or BCM. New replacement transmitters are provided "asleep" and must first ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0074