Nissan Versa

 Sedan Service Manual

Driver controls » Exterior lighting system (EXL) » Parking lamp circuit
Diagnosis Procedure

Regarding Wiring Diagram information, refer to EXL"Wiring Diagram".

1.CHECK PARKING LAMP FUSES

1. Turn the ignition switch OFF.

2. Check that the following fuses are not blown.

Is the fuse blown?

YES >> Replace the fuse after repairing the affected circuit.

NO >> GO TO 2.

2.CHECK PARKING LAMP BULB

Check the applicable lamp bulb to be sure the proper bulb standard is in use and the bulb is not open.

Is the bulb OK?

YES >> GO TO 3.

NO >> Replace the bulb.

3.CHECK TAIL LAMP RELAY OUTPUT (VOLTAGE)

1. Turn the ignition switch OFF.

2. Disconnect the front combination lamp connector, rear combination lamp connector and license plate lamp connector.

3. Turn the ignition switch ON.

4. Turn the parking lamps ON.

5. With the parking lamps ON, check voltage between the front combination lamp connectors and ground.

6. With the parking lamps ON, check voltage between the rear combination lamp connectors and ground.

7. With the parking lamps ON, check voltage between the license plate lamp connector and ground.

Are the inspection results normal?

YES >> GO TO 5.

NO >> GO TO 4.

4.CHECK PARKING, LICENSE PLATE AND TAIL LAMP CIRCUIT (OPEN)

1. Turn the ignition switch OFF.

2. Disconnect IPDM E/R connector.

3. Check continuity between the IPDM E/R harness connector and the front combination lamp harness connector.

4. Check continuity between the IPDM E/R harness connector and the rear combination lamp harness connector.

5. Check continuity between the IPDM E/R harness connector and license plate lamp connector.

Are the inspection results normal?

YES >> Replace IPDM E/R. Refer to PCS "Removal and Installation" (with Intelligent Key) or PCS "Removal and Installation" (without Intelligent Key).

NO >> Repair or replace the harness or connector.

5.CHECK PARKING, LICENSE AND TAIL LAMP GROUND CIRCUITS

1. Check continuity between the front combination lamp harness connectors and ground.

2. Check continuity between the rear combination lamp harness connectors and ground.

3. Check continuity between the license plate lamp harness connectors and ground.

Are the inspection results normal?

YES >> Replace the malfunctioning lamp.

NO >> Repair or replace the harness or connector.

Component Function Check

Diagnosis Procedure