Nissan Versa

 Sedan Service Manual

Body exterior, doors, roof & vehicle security » Security control system (SEC) » B210E Starter relay
Diagnosis Procedure

Regarding Wiring Diagram information, refer to SEC "Wiring Diagram".

1.CHECK STARTER RELAY OUTPUT SIGNAL

1. Check voltage between BCM harness connector and ground

Is the inspection result normal?

YES >> GO TO 4.

NO >> GO TO 2.

2.CHECK STARTER RELAY OUTPUT SIGNAL CIRCUIT

1. Turn ignition switch OFF.       

2. Disconnect BCM connector.

3. Disconnect starter relay.

4. Check continuity between BCM harness connector and starter relay harness connector.

5. Check continuity between BCM harness connector and ground.       

Is the inspection result normal?

YES >> GO TO 3.

NO >> Repair or replace harness.

3.CHECK STARTER RELAY CIRCUIT 1

1. Turn ignition switch OFF.

2. Disconnect IPDM E/R connector.

3. Check continuity between IPDM E/R harness connector and starter relay harness connector.

4. Check continuity between BCM harness connector and ground.

Is the inspection result normal?

YES >> GO TO 6.

NO >> Repair or replace harness.

4.CHECK STARTER RELAY POWER SUPPLY CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect starter relay.

3. Check voltage between starter relay harness connector and ground.

Is the inspection result normal?

YES >> GO TO 5.

NO-1 >> Check 40 A fusible link [Figure H, located in the fuse block (J/B)].

NO-2 >> Check harness for open or short between starter relay and fusible link.

5.CHECK STARTER RELAY CIRCUIT 2

1. Disconnect IPDM E/R connector.

2. Check continuity between IPDM E/R harness connector and starter relay harness connector.

3. Check continuity between BCM harness connector and ground.

Is the inspection result normal?

YES >> GO TO 6.

NO >> Repair or replace harness.

6.CHECK STARTER RELAY

Refer to SEC "Component Inspection".

Is the inspection result normal?

YES >> GO TO 7.

NO >> Replace starter relay.

7.REPLACE BCM

1. Replace BCM. Refer to BCS "Removal and Installation".

2. Perform initialization of BCM and registration of all Intelligent keys using CONSULT.

3. Perform DTC CONFIRMATION PROCEDURE for DTC B210E. Refer to SEC "DTC Logic".

Is the inspection result normal?

YES >> Inspection End.

NO >> Replace IPDM E/R. Refer to PCS "Removal and Installation".

DTC Logic

Diagnosis Procedure

Component Inspection