Nissan Versa

 Sedan Service Manual

Engine » Engine control system (EC) » P0011 IVT control
Component Inspection

1.CHECK INTAKE VALVE TIMING CONTROL SOLENOID VALVEI

1. Turn ignition switch OFF.
2. Disconnect intake valve timing control solenoid valve harness connector.
3. Check resistance between intake valve timing control solenoid valve terminals as follows.

Is the inspection result normal?

YES >> GO TO 2.

NO >> Replace intake valve timing control solenoid valve. Refer to EM, "Exploded View".

2.CHECK INTAKE VALVE TIMING CONTROL SOLENOID VALVEII

1. Remove intake valve timing control solenoid valve. Refer to EM, "Exploded View".
2. Apply 12 V between intake valve timing control solenoid valve terminals 1 and 2, and then interrupt it. Make sure that the plunger moves as shown in the figure.

   CAUTION: Do not apply 12 V continuously for 5 seconds or more.

   Doing so may result in damage to the coil in intake valve timing control solenoid valve.

   NOTE: Always replace Oring when intake valve timing control solenoid valve is removed.

Is the inspection result normal?

YES >> INSPECTION END

NO >> Replace intake valve timing control solenoid valve. Refer to EM, "Exploded View

DTC Logic

Diagnosis Procedure

Component Inspection