For additional information on brake fluid specification, refer to "Recommended fluids/lubricants and capacities" in the "Technical and consumer information" section of this manual.
WARNING
Old, inferior or contaminated fluid may damage the brake and clutch (if so equipped) systems. The use of improper fluids can damage the brake and clutch system and affect the vehicle's stopping ability.
CAUTION
Do not spill the fluid on any painted surfaces.
This will damage the paint. If fluid is spilled, immediately wash the surface with water.

Check the brake fluid level in the reservoir. If the fluid level is below the MIN line B , or the brake warning light comes on, add Genuine NISSAN Brake Fluid or equivalent DOT 3 fluid up to the MAX line A . If fluid must be added frequently, the system should be checked. It is recommended that you visit a NISSAN dealer for this service.

Check the fluid level in the reservoir. The brake fluid reservoir is shared with the clutch hydraulic system for manual transmissions. If the level is below the MIN line B , or the brake warning light comes on, add Genuine NISSAN Brake Fluid or equivalent DOT 3 fluid up to the MAX line A . If fluid must be added frequently, it is recommended that you visit a NISSAN dealer for servicing.
Power steering fluidCheck the fluid level in the reservoir. The fluid level should be checked when the fluid is cold at fluid temperatures of 32 to 86ºF (0 to 30ºC). The fluid level can be checked with ...

Windshield-washer fluid reservoir Add a washer solvent to the windshield-washer fluid reservoir for better cleaning. In the winter season, add a windshield-washer antifreeze. Follow the manufa ...
Wiper and washer switch
Switch operation
Type A (if so equipped)
The windshield wiper and washer operates when
the ignition switch is in the ON position.
Push the lever down to operate the wiper at the
following speed:
Intermittent (INT) - intermittent operation
can be adjusted by turning the knob toward
...
Door check link
DOOR CHECK LINK : Removal and Installation
REMOVAL
Fully close the rear door window.
Remove rear door finisher. Refer to INT-15, "Removal and Installation".
Remove rear door speaker bolts (if equipped).
Disconnect harness connector and remove rear door speaker (if equipped).
...