Nissan Versa

 Sedan Service Manual

Brakes » Brake system (BR) » Brake pad
Brake pad : Inspection

INSPECTION AFTER REMOVAL

Replace the shims if rust is excessively attached.

INSPECTION AFTER INSTALLATION

1. Check a drag of front disc brake. If any drag is found, follow the procedure described below.
2. Remove brake pads. Refer to BR "BRAKE PAD : Removal and Installation".
3. Press the pistons. Refer to BR "BRAKE PAD : Removal and Installation".
4. Install brake pads. Refer to BR "BRAKE PAD : Removal and Installation".
5. Securely depress the brake pedal several times.
6. Check a drag of front disc brake again. If any drag is found, disassemble the cylinder body and replace if necessary. Refer to BR "BRAKE CALIPER ASSEMBLY : Disassembly and Assembly"
7. Burnish contact surfaces brake pads and disc rotor after refinishing or replacing brake pads, or if a soft pedal occurs at very low mileage. Refer to BR "BRAKE PAD : Inspection and Adjustment".

Brake pad : Removal and Installation

Brake pad : Inspection