Nissan Versa

 Sedan Service Manual

Ventilation, heater & air conditioner » Heater & air conditioning control system (HAC)
Air mix door cable

AIR MIX DOOR CABLE : Removal and Installation

REMOVAL

1. Remove foot duct (LH). Refer to VTL "FOOT DUCT : Removal and Installation".
2. Disconnect air mix door cable from A/C control.
3. Disconnect air mix door cable from A/C unit assembly, and then remove air mix door cable.

INSTALLATION

Installation is in the reverse order of removal.

AIR MIX DOOR CABLE : Adjustment

1. Remove cluster lid C. Refer to IP "Removal and Installation".
2. Remove instrument lower panel LH. Refer to IP "Removal and Installation".
3. Remove glove box. Refer to IP "Removal and Installation".
4. Disconnect air mix door cable (1) from clamp (A).
5. Set temperature control dial to full cold position.
6. Push air mix door link (2) in the direction as shown, and then carefully pulling outer cable to A/C control side, and connect clamp.
7. Operate temperature control dial to insure that inner cable moves smoothly.

CAUTION: When clamping the outer cable, do not move the inner cable.

Precautions

Manual air conditioning system

Diagnosis and repair workflow

Operation inspection

A/C On signal

Blower fan on signal

A/C Indicator

Front blower motor

Magnet clutch

Insufficient cooling

Insufficient heating

Compressor does not operate

Front air control

Refrigerant pressure sensor

Blower fan resistor

Intake door cable

Mode door cable

Air mix door cable